HMS - ANYBUS-X J1939-PROFIBUS SLAVE - AB7615

Anybus X-gateway – PROFIBUS Slave - J1939

• Monitor and control data on a J1939 heavy duty vehicle network from PROFIBUS PLC system or device

• Typical applications: Electric Power Generation, Oil & Gas, Marine, Military, Heavy Duty Vehicles, Any Diesel Engine based system supporting J1939

• Max 500 bytes of I/O data in each direction

• Easy configuration via the included BWConfig Windows Software. No programming required

• Robust aluminum stand-alone housing

• Global free technical support and consultancy

• PROFIBUS Slave interface

• PROFIBUS Slave settings can be made either via on-board switches, or by importing the provided .GSD file into engineering tool of the controlling PLC.

• Complete PROFIBUS-DP Slave functionality according to extensions of EN 50170

• Baudrate detection up to 9-12Mbit/s

• 400 bytes total combined Input and Output table size including any status data and command registers

• Cyclic I/O data transmission

• Device diagnostic message transmission

• PROFIBUS slave settings via on-board switches or vis .GSD file

• 1x D-sub 9-pin female PROFIBUS connector

• J1939 interface

• SAE J1939 network interface with a unique network address in accordance to the J1939-81 specification

• Max 496 bytes of I/O Input data and 492 bytes of I/O Output Data

• Up to 120 PGN's monitored by Input data points

• Up to 100 PGN's transmitted by Output data points

• Supports J1939 network baud rates of 250K and 500K

• Transmission and reception of all types of fixed-length J1939 messages, including PDU1, PDU2, broadcast and destination specific

• Monitoring of DM1 (active diagnostics) and DM2 (previously active diagnostics) messages

• Complete network address management including address claim, protection, and yield on higher priority conflict

• Network address can be self-configurable over a range of addresses

• J1939 Transport Protocol for transmission and reception of large messages (9 - 1785 bytes). Both connection based (RTS/CTS) and broadcast (BAM) are supported

• Configurable CAN bus-off reset option will reset the network interface and attempt to return to online when a CAN bus-off condition is detected

• 1x 5-pole 5.08 mm Phoenix pluggable screw connector for J1939